Stereo upgrade for f1503/29/2024 ![]() I removed the grommet, drilled a hole and fed the cable through. This oval grommet was unused and seems to work perfect, the wire runs down the wheel well and enters the cab through a pre-cut circular hole used for mounting a factory device. ![]() ![]() I tried to get through the nipple on that circular grommet but was having a tough time. This is NEXT to the large circular electronics grommet that most people use. Ran the red power cable through a small oval rubber grommet on the passenger side. LC2i - 2 channel line out converter with accubass® and subwoofer controlĪc-lgd - load generating device & signal stabilizer TS-SW2502S4 10" Shallow-Mount Subwoofer with 1,200 Watts Max. Still determining if I am going to cut the factory interior fabric on the back wall of the cab so the sub enclosure can rest against the wall, and allow the folding seat to lift and lock in place allowing for floor storage. Which will fit behind the rear driver's side seat perfectly. Pioneer UD-SW250T Shallow Sub Sealed Enclosure I went to a local store, and after a LOT of online research (much in the forums) Equipment is as follows: Let me start by saying I have some experience dis-assembling an aftermarket deck/sub/amp set up, but have no experience assembling, and much less with a factory head unit. Hi all, I am upgrading my 2018 Lariat with the standard stereo system (non-B&O) to include an amplifier, 10" Sub Woofer, and would like to run amp power to the front door speakers.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |